SPONSORS
2024 ICRBE EXPO |
Tip question
Posted by:
Cutter Smith
(---.hsd1.ct.comcast.net)
Date: April 25, 2018 09:51PM
Another novice question from me...
I’m just finishing a 7’6” rainshadow spinning rod. I’m using Fuji BKLAG -H 06L for runners. The vendor I bought the components recommended a BFAT 6 for a tip. The runners sit a bit higher off the rod then the tip. Is this ok or should I have gotten a different tip a with similar height off the rod? Thanks in advance! Cutter Re: Tip question
Posted by:
roger wilson
(---.hsd1.mn.comcast.net)
Date: April 25, 2018 10:30PM
Cutter,
It will be a great tip. Not a bad idea to have the tip ring close to the blank. Good luck Re: Tip question
Posted by:
roger wilson
(---.hsd1.mn.comcast.net)
Date: April 25, 2018 10:32PM
Cutter,
It will be a great tip. Not a bad idea to have the tip ring close to the blank. Good luck Re: Tip question
Posted by:
Michael Danek
(---.alma.mi.frontiernet.net)
Date: April 26, 2018 08:02AM
No problem. Misalignment of guides is not the issue many think it is. Re: Tip question
Posted by:
ben belote
(---.zoominternet.net)
Date: April 26, 2018 08:19AM
Michael, so true..otherwise we would still be using the cone of flight system and no choke guide at all..lol. Re: Tip question
Posted by:
Cutter Smith
(---.hsd1.ct.comcast.net)
Date: April 26, 2018 06:10PM
Great. Thanks for the quick response. Time to finish this rod! Sorry, only registered users may post in this forum.
|