SPONSORS
2024 ICRBE EXPO |
Reel Seat Parts
Posted by:
Chad St.Amand
(---.bchsia.telus.net)
Date: November 28, 2017 11:03PM
Hey Guys,
I am trying to make some custom turned spinning seats and I am looking for the piece that glues on to the top of the seat?(Not sure what the technical term is) I see I can buy the nut piece just about anywhere but not the top part. Thanks for the help Chad Re: Reel Seat Parts
Posted by:
Chuck McIntyre
(172.58.56.---)
Date: November 28, 2017 11:44PM
I believe you are looking for the fixed hood. Re: Reel Seat Parts
Posted by:
roger wilson
(---.hsd1.mn.comcast.net)
Date: November 29, 2017 12:57AM
Chad,
Are you going to be doing anything more than making the center section of a reel seat? If so, you just need to purchase a skeletal reel seat for the rest of the seat: [www.mudhole.com] [www.mudhole.com] [www.mudhole.com] [www.mudhole.com] Here is a skeletal reel seat: I have built many rods using this seat with a turned center section that fits between the hood and the threaded portion of the reel seat: [www.mudhole.com] An example of a skeletal reel seat with a turned wood center section. Normally the ends of the turned section are sized to fit inside the hood section for very good seat stability: [www.mudhole.com] Some colorful skeletal reel seats: [www.mudhole.com] Re: Reel Seat Parts
Posted by:
Chad St.Amand
(---.bchsia.telus.net)
Date: November 29, 2017 01:00AM
Yes roger that i guess would be exactly what I am looking for.
Thanks As always Re: Reel Seat Parts
Posted by:
Matthew Pitrowski
(---.lightspeed.milwwi.sbcglobal.net)
Date: November 29, 2017 08:33PM
you can also just buy a regular reel seat and cut the reel foot section out and add your insert . The best day to be alive is always tomorrow !! Think out side the box when all else fails !!! Wi. Sorry, only registered users may post in this forum.
|