Untitled Document

Please register before attempting to upload photos. You must use your actual first and last name and a valid email address when you register. Internet handles and nicknames are not allowed. You will receive an email account verification shortly after you register. Please follow the enclosed instructions in order to activate your rodbuilding.org photo account.

Please limit your photo uploads to those directly associated with custom rod building. Occasional photos of fish caught on your custom rods are acceptable, however, and should be placed in the “miscellaneous” category.

SunMon TueWed ThuFri Sat
  12345
6789101112
13141516171819
20212223242526
2728293031  

DSCI0005.JPG

spine marker - laundry clip
Rainer Schaefers

[ Equipment and Tools ]
DSCN0032.jpg

Rod Lathe Tensioner Upgrade
Bill Stevens

[ Equipment and Tools ]
MY_EzWrapper.jpg

Ez Wrapper Plus - Prototype
Ben Lee

[ Equipment and Tools ]
DSC00017.JPG

RodHolder...
MaryLou VandeRiet

[ Equipment and Tools ]
benchjpg.jpg

Rod Lathe Bench
Tom Kirkman

[ Equipment and Tools ]
Cork_Clamp-med.jpg

Cork Clamp
Mike Barkley

[ Equipment and Tools ]
· more ·

 
« more
Picture_050.jpg
Picture_049.jpg
Picture_001.jpg
MVC-016S.JPG
Trim_Band_Bobbin_1.JPG
rod_building_019.JPG
rod_building_016.JPG
rod_building_015.JPG
Pac-Bay_Chuck.JPG
CTS_Rod.jpg
Thread_Carrage.jpg
New_4.JPG
New_3.JPG
New_1.JPG
powerwrapperrebuild.jpg
P2020002.JPG
WrappingJig.JPG
Indicator_under_load.jpg
Guitar_string_srtike_indicator.jpg
wrapper.jpg
Rod_Dryer_with_Timer.JPG
· more »

« Previous image · Next image »

Thread Carrage on 1080 Rail
Thread Carrage on 1080 Rail

Click on image to view larger image

« Previous image  · Slide Show · Next image »

Barry Thomas Sr



Registered: January 2008
Location: Cape May Nj.
Posts: 114
users gallery
this is the Proto-type have a New piece of Delrin waiting.Slides on brass rollers. using a Neptune tension device


· Date: Tue February 12, 2008 · Views: 4,947 · Filesize: 37.6kb, 48.6kb · Dimensions: 640 x 480 ·
Keywords: Thread Carrage on 1080 Rail


Henry Engle

Registered: April 2007
Posts: 19
Sun March 2, 2008 12:06am

You need some way to take up the slack when you reverse the blank to fix soemthing.


Actually that platform can just sit behine the lathe on the table if its heavy enough and just be moved around back there without interfering with anything. Doesnt have to be a attached to the wrapper at all.


Photo Sharing Gallery by PhotoPost
Copyright © 2007 All Enthusiast, Inc.