|
|
Scott Parsons
Registered: September 2005
Location: Raleigh, NC
Posts: 98
|
|
Wed October 10, 2007 3:43pm
|
|
|
Billy what type of saw do you cut these with? Thanks
|
|
Raymond_Adams
Registered: May 2005
Location: Sacramento, CA
Posts: 2,244
|
|
Wed October 10, 2007 10:33pm
|
|
|
Re: Slicing EVA
Posted by: Billy Vivona (160.254.108.---)
Date: October 9, 2007 10:54AM
When was the last time anyone has seen someone post a picture of an angled cut of EVA?
When making your angled cut, you'll probably have to reposition the fence & miter guage to switch over to or from cutting straight rings, unless you're making Vee shapes in the grip with a 45 on both sides, which will take more time than making the trim rings and sticking a grip in a Miter box to be cut with a serrated bread knife.
NERBS - North East Rod Builders
|
|
BIlly Vivona
Registered: March 2005
Location: Staten Island, New York
Posts: 2,910
|
|
Thu October 11, 2007 1:10pm
|
|
|
Scott, as Ray quoted, it's a band saw. I use a Grizzly $325 model from 2006. I WISH I got the better one with better fence, miter guage & measuring thingy on the table. At some point I may try to sell this one and get the better one, especially if I get into wood at all.
------------------------------
****** Unique products for rod builders: [ link ] click the link ******
|
|
|
|
