|
|
Randy Search
Registered: February 2006
Posts: 78
|
|
Sat December 9, 2006 3:43pm
|
|
|
Italo,
Is that a sander/grinder combo on the right side of your table? If so, could you tell me the make? Thanks, Randy.
|
|
Italo Busi
Registered: August 2005
Location: Roma Italy
Posts: 596
|
|
Sat December 9, 2006 4:15pm
|
|
|
Hello Randy, how are you !!!
I hope to see you again in N.C. !!
Yes it is, I sametime use it for sand the wood ogive before to put it on the electronic lathe (I will post tomorrow the picture) , or sand the butt blank . I often use the grinder for my stainless steel tool , when I needed to sharpen it for use on the mini lathe .
Of course I go in another room , to avoid to make the dust .
Ciao my friend, Italo
|
|
Donald Newenhouse
Registered: November 2006
Posts: 57
|
|
Sat December 9, 2006 5:57pm
|
|
|
Italo< The lighting that you have above your work table.Does that give off ample light to work with or do you have other lights??Thanks >
|
|
Italo Busi
Registered: August 2005
Location: Roma Italy
Posts: 596
|
|
Sun December 10, 2006 2:23am
|
|
|
Hello Donald, they are 3 low energy white hot lamp and they are 200 watt each , plus I have up the cieling another two 100 watt lamp, but I use this only when I have costomers in my workshop because they give light on the rods rack.
Ciao Italo
|
|
|
|
