Apple wood handle and nickle insert

Untitled Document

Please register before attempting to upload photos. You must use your actual first and last name and a valid email address when you register. Internet handles and nicknames are not allowed. You will receive an email account verification shortly after you register. Please follow the enclosed instructions in order to activate your rodbuilding.org photo account.

Please limit your photo uploads to those directly associated with custom rod building. Occasional photos of fish caught on your custom rods are acceptable, however, and should be placed in the “miscellaneous” category.

Home · Search · Member List · Register · Login

Most Recent · Most Popular · Random
[Grips, Handles and Reel Seats]

IMG00073-20110131-1926
mike burnette

[ Grips, Handles and Reel Seats ]

WV Maple black Center Pin rod
mark crouse

[ Grips, Handles and Reel Seats ]

St. Croix IV with Angler's Roost Dragonwood Seat
Ladd Flock

[ Grips, Handles and Reel Seats ]

Twisted
William Marchisella

[ Grips, Handles and Reel Seats ]

True Oil Products
Bill Stevens

[ Grips, Handles and Reel Seats ]

Leather and Feathers
MARCO ANTONIO SILVA

[ Grips, Handles and Reel Seats ]

· more ·

Home » RodBuilding.org » Grips, Handles and Reel Seats

« Previous image · Slide Show · Next image »

« more

· more »

« Previous image · Next image »

Apple wood handle and nickle insert

Click on image to view larger image

« Previous image · Slide Show · Next image »

Photo Details
Scott VanGuilder Registered: March 2005 Location: Chisholm, MN Posts: 265	Apple wood handle and a nickle insert on a 7' 2 piece hvy wt st croix pike rod.
	· Date: Wed June 14, 2006 · Views: 2,825 · Filesize: 21.7kb, 32.4kb · Dimensions: 710 x 361 ·
	Additional Info
	Keywords: Apple wood handle nickle insert

Author

Thread

Michael Joyce

Registered: March 2005
Location: Central MA
Posts: 1,528

Wed June 14, 2006 7:35pm

Clean and sharp.

Scott VanGuilder

Registered: March 2005
Location: Chisholm, MN
Posts: 265

Wed June 14, 2006 7:41pm

Thanks Mike!! Coming from you that is a real compliment.

STEVEN COX

Registered: November 2006
Posts: 282

Thu May 3, 2007 10:50pm

Nice job Scott. How did you carve/groove the indention fot the coin? Thanks

Scott VanGuilder

Registered: March 2005
Location: Chisholm, MN
Posts: 265

Mon May 7, 2007 10:47am

I did in the lathe...very carefully. I started but using a wood bit as close as possible to the OD of the nickel, then used a part off tool slowly open up it up to the size of the nickel.