Untitled Document

Please register before attempting to upload photos. You must use your actual first and last name and a valid email address when you register. Internet handles and nicknames are not allowed. You will receive an email account verification shortly after you register. Please follow the enclosed instructions in order to activate your rodbuilding.org photo account.

Please limit your photo uploads to those directly associated with custom rod building. Occasional photos of fish caught on your custom rods are acceptable, however, and should be placed in the “miscellaneous” category.

SunMon TueWed ThuFri Sat
  12345
6789101112
13141516171819
20212223242526
2728293031  

Tape_splitting.jpg

Splitting wide tape on lathe
John Repaci

[ Equipment and Tools ]
DSCN1440.JPG

Motor and chuck assembly
Mike DeKeyser

[ Equipment and Tools ]
P1170006.JPG

Epoxy Mixer
Lynn Williams

[ Equipment and Tools ]
1a1.jpg

Cork Lathe
Don Morse

[ Equipment and Tools ]
PG_Can_1.JPG

Permaglos Can
Jim Upton

[ Equipment and Tools ]
Rod_Wrapper_with_all_hardwear.JPG

rod wrapper
Eric Viburs

[ Equipment and Tools ]
· more ·

 
« more
IMG_0262.JPG
Poign_e_Jacquot.JPG
Chuck.JPG
Timed_rod_dryer.jpg
IMG_0368.JPG
DSCF1111_940_x_705_.jpg
FUll_pegboard.jpg
Rod_Wrapper_with_all_hardwear.JPG
Lathe2.jpg
IMG_02631.JPG
Composite_angle_6.jpg
DSCN22061.JPG
weavejig2.jpg
weavejig1.jpg
DSC_0001_800x532_.jpg
thread_stand.jpg
static_test_guide_mounter.JPG
DSC03461.JPG
1budowajig.jpg
IMG_1104.JPG
CCS_Board.jpg
· more »

« Previous image · Next image »

Angle grinder as chop saw
Angle grinder as chop saw

Click on image to view larger image

« Previous image  · Slide Show · Next image »

roger wilson



Registered: April 2007
Posts: 89
users gallery
Here is a picture of a 4 1/2 inch angle grinder converted to a chop saw with a $10 clamp.
Unfortunately much of the clamp assembly was worthless and had to be thrown away. The hinge assembly was machined and shims added to tighten up the hinge. Then, steel, aluminum and wood were used to construct a new base for the angle grinder to replace the flimsy base that came with the clamp kit.
· Date: Tue April 12, 2011 · Views: 1,099 · Filesize: 27.9kb, 131.2kb · Dimensions: 1844 x 855 ·
Keywords: Angle grinder as chop saw



Photo Sharing Gallery by PhotoPost
Copyright © 2007 All Enthusiast, Inc.