|
|
|
|
|
« Previous image · Next image »
butt wrap
Click on image to view larger image
« Previous image · Slide Show · Next image »
Daniel Burney
Registered: November 2006
Location: Texas
Posts: 33
|
5 coats of flexcoat hi build and still not level. should i have kept putting more coats on until it levelled up or what?
|
| · Date: Mon September 13, 2010 · Views: 386 · Filesize: 33.8kb, 201.6kb · Dimensions: 2000 x 1497 ·
|
|
Keywords: butt wrap
|
|
|
Raymond_Adams
Registered: May 2005
Location: Sacramento, CA
Posts: 2,244
|
|
Mon September 13, 2010 12:57pm
|
|
|
The only way to get the finish completely flat on an open butt-wrap is to build the finish up and then block sand down the high spots level with the lower spots and then add a final thin coat. You must build up the finish until the low spots are higher than the actual level of the thread or you just end up sanding into the thread and then it's all over but the crying and the re-wrap!
What's happening is the thread is higher than the blank so matter how much finish you apply the high & low areas remain the same relative to each other.
|
|
|
|
