|
|
|
|
|
« Previous image · Next image »
Micro guides-holding on rod
Click on image to view larger image
« Previous image · Slide Show · Next image »
Duane Richards DR
Registered: May 2008
Location: Vinton, VA
Posts: 231
|
Here is a pic of my set up for adjusting and holding micro guides for placement and wrapping. What you see is a stainless steel thread burnishing/packing tool, a roll of 1/8" tubing that is similar to surgical tubing, and some of the tubing cut with scissors into little rubber bands lying on the penny. The thread tool has a 3mm batson micro guide being held onto it with one of the rubber bands doubled over. Use the tool to double over the bands to make them tight and slide the rubber band off the tool and directly onto the rod blank tip.
|
| · Date: Sun March 7, 2010 · Views: 1,497 · Filesize: 44.7kb, 233.5kb · Dimensions: 2000 x 1500 ·
|
|
Keywords: micro
|
|
|
Roger Rierson
Registered: September 2006
Location: Greensboro, NC
Posts: 3
|
|
Mon March 8, 2010 11:12am
|
|
|
Where do you find the 1/8" tubing?
|
|
Duane Richards DR
Registered: May 2008
Location: Vinton, VA
Posts: 231
|
|
|
Merrick Tackle (item # MPTT18) has it Roger, and I'll bet others have it also, try them or Mudhole.
DR
|
|
|
|
